Eibach Pro-Spacer 60 mm Rear Wheel Spacers for Mustang 2005–2014

Eibach Pro-Spacer wheel spacers for the rear axle of the Ford Mustang 2005–2014 – 60 mm per axle or 30 mm per wheel.

Eibach Pro-Spacer wheel spacers increase the track width of the Mustang and allow the position of the wheels within the wheel arches to be adjusted. This set is designed for the rear axle and increases the total track width by 60 mm – 30 mm per wheel.

The silver anodised aluminium spacers use the Eibach System 4. The spacers are bolted directly to the vehicle using the supplied mounting hardware, with integrated wheel studs then used to mount the wheel.

60 mm wider track at the rear axle

• 60 mm track increase per axle
• 30 mm spacer per wheel
• for the rear axle
• Eibach Pro-Spacer System 4
• bolt-on system with wheel studs
• aluminium construction
• silver anodised finish
• mounting hardware included
• Teilegutachten included

Suitable for

• Ford Mustang 2005–2014
• Coupe and Convertible
• rear axle

Which spacer width fits my Mustang?

The spacer width that can actually be used on your Mustang depends on the individual vehicle and wheel/tyre combination. Important factors include wheel width, offset, tyre size, vehicle ride height, wheel clearance and sufficient tyre coverage.

Installation and approval

The System 4 spacers are attached to the vehicle using the specified mounting hardware. The wheel is then mounted to the studs integrated into the spacer.

For use in Germany, an inspection according to §19(3) StVZO is required after installation in accordance with the supplied Teilegutachten. All requirements applicable to the respective wheel and tyre combination must be observed.

The mounting hardware must be checked and retightened after installation in accordance with Eibach's instructions.

Scope of delivery

• 2x Eibach Pro-Spacer 30 mm wheel spacer
• mounting hardware
• Teilegutachten

Eibach part number: S90-4-30-020

Image for illustration purposes only – the product image shows a standard Eibach Pro-Spacer image. The actual product supplied may differ in appearance.